Page 1 of 1
A series question
Posted: Fri May 24, 2013 8:57 pm
by 2 doors
Can anyone please tell me the distance between the cylinder head and strut tower on a 1200?
Re: A series question
Posted: Fri May 24, 2013 9:15 pm
by jas1200
Will measure tomorrow for you. Is this for clearance for your turbo?
Re: A series question
Posted: Fri May 24, 2013 9:20 pm
by 2 doors
turbo wont be a problem, just want to be sure the plenum will fit when I make it, thanks
Re: A series question
Posted: Sat May 25, 2013 10:47 am
by jas1200
About 280mm to 285mm....thats horizontal from the head. As the strut tower tappers out us you move up that measurment incresses 335mm from the face of the inlet port to the top of the strut tower.
Re: A series question
Posted: Sat May 25, 2013 11:16 am
by 2 doors
fantastic, thanks very much