Page 1 of 2
Bike carbs and manifolds for A12
Posted: Sun May 26, 2013 3:16 pm
by Tony.buchler
Pulled these off my engine as I'm buying dellorto 35's
Thought I'd see if anyone here was interested before going on TM.
They are off a Honda CB900 (so I was told by the mechanic who
Put them on).
Re: Bike carbs and manifolds for A12
Posted: Sun May 26, 2013 3:25 pm
by Tony.buchler
More pics of the carbs
Re: Bike carbs and manifolds for A12
Posted: Sun May 26, 2013 3:54 pm
by beaver
Dibs.
Were they running on the motor? How much you after?
I have a set of bike carbs already but depending on what you want for everything could be keen on the lot.
Re: Bike carbs and manifolds for A12
Posted: Sun May 26, 2013 5:12 pm
by damz721
F$&# too slow, also keen as..
Re: Bike carbs and manifolds for A12
Posted: Sun May 26, 2013 5:38 pm
by beaver
Gotta be quick round here haha, been in touch with him, sold pending payment etc
Re: Bike carbs and manifolds for A12
Posted: Sun May 26, 2013 5:58 pm
by Tony.buchler
Christ. Didn't even expect anyone to want them lol
Re: Bike carbs and manifolds for A12
Posted: Thu Jun 27, 2013 8:26 pm
by Sloky
Hi is this worth doing I have a set in a box in the workshop . might put them on .
Re: Bike carbs and manifolds for A12
Posted: Thu Jun 27, 2013 9:17 pm
by Bartman
If you can get them running right, I'd say yes!
You'd probably have to know what you're doing to get them tuned right though. (I sure don't)
Most bike carb float needles don't like normal fuel pressure. many bikes only run gravity feed.
Re: Bike carbs and manifolds for A12
Posted: Fri Jun 28, 2013 5:36 pm
by Sloky
sweet better start my manifold then
thanks for your answer
Re: Bike carbs and manifolds for A12
Posted: Sat Jun 29, 2013 12:10 pm
by Bartman
Start a build thread, and post lots of pictures!