New Zealand Datsun Club

Hey people I've got a few bits left from my fj20 days.

I have a crank shaft,still standard needs a regrind though.
A set of cam shafts and a inlet manifold and timing cover no oil pump could have more ill update if i find anything else.

Make an offer anything considered

No cylinder heads?

Is this for turbo setup? I'm wanting to turb my fj20de and lookin for parts, how much you lookin for $$ wise?

No heads mate it is a turbo manifold with turbo on it too

How much for the camshafts?

cams are the same for turbo and non. the cam gears are different, even then i think its the exhaust one only...

Is the inlet manifold a turbo one? Do you know if it's off a DR or S12?

The inlet is off a dr30 the big manifold has turbo on it.
I was told buy a fj20 guy that the cam were not the same diff lift and duration i can ask a mate of mine ( Who grinds cams if and the differences are if that would help. $100 make an offer ?

chris_g1 wrote:I was told buy a fj20 guy that the cam were not the same diff lift and duration i can ask a mate of mine ( Who grinds cams if and the differences are if that would help. $100 make an offer ?

and ive been told the opposite.
i can tell you i have compared my NA and turbo gears and they are different.

also depends on the engine too.
i have a new NZ NA FJ20e that only has different pistons,pulleys and rods. everything else is the same as a turbo one.

348" cam lift. 214 degrees @ .050" and 288 @ .010".