Page 1 of 1
510 clutch master questions
Posted: Tue Nov 05, 2013 9:55 pm
by jeremiahnz
Hi guys,
Can anyone let me know the thread pitch on 510 clutch master?
Also anyone know a good place to source one (preferably new) and a rough cost? There is possibly one on trademe, just trying to clarify some stuff to see if it is right.
Btw this is to go on my 410.
Thanks
Re: 510 clutch master questions
Posted: Tue Nov 05, 2013 11:43 pm
by broke
M10x1.0, you can still buy them new from BNT etc.
Re: 510 clutch master questions
Posted: Wed Nov 06, 2013 7:40 am
by jeremiahnz
Thanks
Follow up question - anyone know good places to get 3/8-24 to m10x1.0 adapters. Online in nz would be good
Re: Re: 510 clutch master questions
Posted: Wed Nov 06, 2013 10:12 am
by Datto_610
broke wrote:M10x1.0, you can still buy them new from BNT etc.
Not so sure about that John, I don't think Brock could get one for pips 140j which is the same as 510 & 610. I got mine from ebay as I couldn't get a new one in NZ
Sent from my GT-I9300 using Tapatalk 2
Re: 510 clutch master questions
Posted: Wed Nov 06, 2013 1:27 pm
by broke
Really? Stink, I guess ebay would be the go then.
As for the adaptor, if you really want 3/8" you could get them from Greenlane Speed Shop, or use 7/16 and go to any Hydraulink and ask for G-M-0710, or you could go to Fluid Fittings or Fluid Connectors.
My C32 and Greg's 180B both use 7/16" JIC adaptors and 3/16" hose. I'd link the build threads if I wasn't on my phone.
Re: 510 clutch master questions
Posted: Thu Nov 07, 2013 8:48 pm
by jeremiahnz
Yep can confirm that BNT doesn't do them new anymore.
Will try GSS for the adapter. Don't particurlarly want 3/8 but the slave has that thread and it is one less thing to change.
Thanks