New Zealand Datsun Club

So I recently had my front seats recovered in bride material, they look amazing!

At first I was going to run those in the front and factory 1600 vinyl seat in the back... Now I think I want to re-trim a back seat with the left over bride material I have..

What seats would match recaro fishnets and almost bolt straight in? S14, r32 gtr etc

Cheers datsun fiends!!!!!!!

Good question.
I sat in the back of a 510 once, and it was terrible.
Best bet might be to head to pick a part with a tape measure?

An s14 seat comes pretty close to fitting, had one dummied up in my brothers 510 project. The back of the s14 mounts via bolts through the rear wheel arch, with a few small mods and new material (as you will need to fill in the bottom middle section underneath as it has a step for trans tunnel).

Yip id try an S14 seat, With a little extra foam its a perfect fit for a Datsun 710.

I have a spare S14 seat if you want it. Freight would be killer though.

I believe my rear seat in my 510 is an S14 number. Could send you some pics if you want...

DatsunP510 wrote:I believe my rear seat in my 510 is an S14 number. Could send you some pics if you want...

Photos would be sweet!!!!

unlimitedpower wrote:Yip id try an S14 seat, With a little extra foam its a perfect fit for a Datsun 710.

I have a spare S14 seat if you want it. Freight would be killer though.

Oh damn! thats all good thanks heaps anyway

Could you post some pics for me? Mainly where you put extra foam...