Page 1 of 1
240C/260C sheet metal parts
Posted: Mon Apr 14, 2014 11:43 pm
by Reverend
Im interested in any low rust or rust free sheet metal parts for my 1979 330 Cedric. Special need for floorboards, rear compartment area and wheel arches (rear). No matter if used or dinged.
CheerZ
spacereverend@gmail.com
Re: 240C/260C sheet metal parts
Posted: Tue Apr 15, 2014 9:00 pm
by Bartman
Karl isn't going to need the floorpan from the 330 that RBlover was parting out.
I'm not sure where you are, but freight would be horrendus.
Re: 240C/260C sheet metal parts
Posted: Wed Apr 16, 2014 11:59 pm
by Reverend
Just noticed i replied with pm... lol. Guess im not that used to these forums. If the shipping is not overkill, im more than interested.
Re: 240C/260C sheet metal parts
Posted: Sun May 04, 2014 6:46 am
by Jani
Automotive panel craft tekee korjauspaloja mutta niiltäkään ei taida löytyä tuohon mitään. 510 ja 610 on hyvin edustettuna mutta siihen taitaa jäädä.. Jos lyödät jostainpäin Australiaa purkaamon mistä olisi mahdollista saada C110:n palikoita niin minulle saa kertoa..
Jani