Complete A15 setup for a 1200 ute
Posted: Thu Oct 02, 2014 8:42 pm
Selling my A15 set up in my 1200 sunny ute
For sale:
SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD
SOLD THE WHOLE CONVERSION ....
A15 black top imported from jap from a c22 vanette early 90's model had 125k on it when installed in my ute .. Excellent running motor very clean, no oil leaks and doesn't go through oil, new plugs, leads, rotor button, dissie cap, coil pack less than 10k ago comes with starter motor and alternator, can be herd running and test driven before purchase ! $500
Modified inlet manifold to suit extractors and 32/36 DGAV webber
Rebuilt 32/36 dgav webber and brand new air filter less than 5k ago $350 for the carby, manifold and acellarator cable.
60a series 5sp standard patten and gearbox mount not in the best condition still drivable but the synco's in second and third need to be replaced they crunch when going down the gears ... $200
Gearbox sold
Clutch in good condition grabs really well comes with clutch cable.. can tested before buying $145
Master cylinder $100
4into1 extractors and full 2-1/2 exhaust to suit a 1200 ute $300
Standard 1200 radiator good condition and piping $120
1200 ute engine cross member to suit an A15 $120
Their is probably some stuff I have missed but I will post over the Wkend .... And photos to will be putting up on trade me to
I don't want to separate yet as I want to give a chance for a buyer to test run the motor ect reason for selling is I'm about to start my ca18det conversion .... I will eventually be selling a good working h165 diff to
For sale:
SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD
SOLD THE WHOLE CONVERSION ....
A15 black top imported from jap from a c22 vanette early 90's model had 125k on it when installed in my ute .. Excellent running motor very clean, no oil leaks and doesn't go through oil, new plugs, leads, rotor button, dissie cap, coil pack less than 10k ago comes with starter motor and alternator, can be herd running and test driven before purchase ! $500
Modified inlet manifold to suit extractors and 32/36 DGAV webber
Rebuilt 32/36 dgav webber and brand new air filter less than 5k ago $350 for the carby, manifold and acellarator cable.
60a series 5sp standard patten and gearbox mount not in the best condition still drivable but the synco's in second and third need to be replaced they crunch when going down the gears ... $200
Gearbox sold
Clutch in good condition grabs really well comes with clutch cable.. can tested before buying $145
Master cylinder $100
4into1 extractors and full 2-1/2 exhaust to suit a 1200 ute $300
Standard 1200 radiator good condition and piping $120
1200 ute engine cross member to suit an A15 $120
Their is probably some stuff I have missed but I will post over the Wkend .... And photos to will be putting up on trade me to
I don't want to separate yet as I want to give a chance for a buyer to test run the motor ect reason for selling is I'm about to start my ca18det conversion .... I will eventually be selling a good working h165 diff to