New Zealand Datsun Club

Can some one do me a favour and take a quick measurement for me.

I need to know the OD of a main bearing on a Datsun L series motor.

This is not the size or the crank but around the outside of the bearing.
Or the size of the journal with no bearings in it.

My only block I have is packed away and I can't get to it easily and it has a crank in it.
And have no old or new bearings to measure.

Thanks
Brett

Does 58.658mm sound about right for the bore diameter? Found it here:

http://www.ndcenginebearing.com/pdf/shopmanual.pdf

Thanks mate spot on. Just what I wanted to know.
I tried googling but have breatheran computers at work which block me out of almost everything

Ah the Breath'
They're an interesting bunch.