Page 1 of 1
Automotive Panel Craft Aussie
Posted: Sat Dec 20, 2014 2:26 pm
by R3spct
Im ordering some sills and a rear quarter panel for my 1200 coupe, anyone else need and panels from them?
Re: Automotive Panel Craft Aussie
Posted: Tue Dec 23, 2014 7:34 pm
by Tony.buchler
When are you ordering the panels?
Re: Automotive Panel Craft Aussie
Posted: Tue Dec 23, 2014 10:20 pm
by nzdatman
don't need them yet so I wont order now but I'm very very keen to see how the bits are quality wise when you go to fit them to your coupe. as I was thinking of using them too.
Re: Automotive Panel Craft Aussie
Posted: Tue Dec 23, 2014 10:27 pm
by mint16
I could be keen on rust panels also during Jan/Feb.
Re: Automotive Panel Craft Aussie
Posted: Wed Dec 24, 2014 7:48 am
by Tony.buchler
nzdatman wrote:don't need them yet so I wont order now but I'm very very keen to see how the bits are quality wise when you go to fit them to your coupe. as I was thinking of using them too.
I bought 4 Thaiwanese sill panels earlier this year to replace the ones on my sedan. They fit real well. They were for the coupe so reversed one on each side to make up the extra length. The skirt panels behind front guards and gutter panels from Apc are a good fit also
Re: Automotive Panel Craft Aussie
Posted: Tue Jan 13, 2015 7:24 pm
by Meandatto
These guys panels are top quality perfect fit ! I used their floor pans in my 1200 ute back in oz .... They use a thicker gauge steel compared to the after market Chinese ones and the come pre primed ready for paint !