Page 1 of 1

Parts clean out - Updated

Posted: Fri Jan 09, 2015 10:05 am
by Kitch
Parts available for sale:

Note: NORS = New old replica stock.

> New genuine Nissan 1200 sedan/ute front 1/4 vent window rubber seals (brought in from Japan in error, damn I need some coupe ones!) cost me $250
Image

> Front grill emblem to suit 1200 coupe plastic grill, good condition, polished and brush painted $40

> 1200 Coupe Tail light complete assemblies (good condition but need clean up) $120 for complete pair
Image

> 1200 Coupe skuttle panel vents and back grills, couple of cracks around screw holes, should suit to upgrade sedan or ute too $80
Image

> NORS 1200 coupe boot seal (fitted then removed to fit genuine seal) $20

> NORS A series clutch cable to suit 4 speed gearbox $45
Image

> 1200 Coupe Side fender grills x2
Image

> Wildcat style Sports steering wheel with Datsun centre in great condition $150
Image

> B210 GX Steering wheel in great condition, suit 1200 or 120Y - genuine offers
Image

> 1200 Coupe clip on door Window frame & B Pillar trim set
Image

> 1200 Hand brake surround plastic
Image

>1200 Coupe door cards (Luke has first dibs)
Image

> 1200 chrome; bonnet front chrome, also lower chrome that goes under grill
Image

> 1200 sedan/ute NORS front windscreen rubber & 120Y rear windscreen
Image


Will add to edit / stuff as I dig it out.
PM or txt me if keen on anything

Re: Parts clean out

Posted: Fri Jan 09, 2015 1:09 pm
by 2 doors
WOW timing is everything ill take the door seals,

Re: Parts clean out

Posted: Sat Jan 10, 2015 8:53 pm
by mint16
Coupe doors seals will be different to 2 door sedan seals due to A-pillar angle.

Re: Parts clean out

Posted: Sat Jan 10, 2015 9:14 pm
by Tony.buchler
The scuttle panel vents... Are they the stickie uppie ones? ;)

Re: Parts clean out

Posted: Sat Jan 10, 2015 9:18 pm
by 2 doors
mint16 wrote:Coupe doors seals will be different to 2 door sedan seals due to A-pillar angle.
Yip had that discussion cheers, and the height will be different as well, so will get them up here and see if they fit, they area universal seal by the sounds of things

Re: Parts clean out - Updated

Posted: Sun Jan 11, 2015 8:45 am
by Kitch
Tony, yes raised type vents - pic added on original post above

Re: Parts clean out - Updated

Posted: Sun Jan 11, 2015 9:14 am
by luke
IL take the front end chrome, and will get Lewis to compare door cards for me

Re: Parts clean out - Updated

Posted: Sun Jan 11, 2015 10:21 am
by Kitch
OK Luke, not a prob