New Zealand Datsun Club

Hey guys im new to the site.
From pukekohe.

I'm converting a mitsi efi system to fit an a15 and wondered if anyone makes up or has an alloy intake flange? Just need the two individual flanges in 10mm alloy as packer from runners to head.

Cheers

probly cheaper just to buy a a15 manifold and cut it up or you would need a template like a manifold gasket and then cut it out of some alloy etc

im sure we would be keen as a club for you to start a build thread with pictures and info etc

I wasn't sure if a manifold would need to be skimmed flat after cutting up.
If it doesn't then that would be cheapest option.
Cost about $60-100 to have plates made up.

I will start a thread up for people to follow.

Try Kitch. Check out his awesome 1200 build, you will probably find some Inspiration and motivation there.

happen to have a schematic/diagram of what you want, might be able to do something at work on the side cheeeeeep for ya

works being mental, and multiple personal/mates projects on go... ive low keyd orded a sheet of 12mm alloy. hopefully give you a update in next coupledays

Edit: i might get a side slap from boss or a no piss off, we didnt have any scrap suitable... being a eng firm on the useless Wcoast, it mostly heavy argricutl eng here

How did ya get on with the cut out? If there is no material around just make the square exhaust flanges or of 10mm mild and I can get alloy flanges cut up here.