New Zealand Datsun Club

Having a bit of a clean up at my shed need to sell this stuff before I get sick of it and dump it

2 dr30 steering boxes and p/steer pumps, ones a bit sad and the other was sold to me as good but I've never personally run it, offers

R200 long nose lad with rebuilt axles, was going to keep this as a just in case setup but have cut the subframe mounts out of the car so it's not gonna happen, could probably use a new set of plates but it's still got life in it. Also have dr30 rear lower arms with hubs and crossmember, offers

S12 power steer rack, looks good , never used it, offers
Z33"same as above" but also has subframe

Factory fj20et turbo, suit rebuild it's got a wee bit of play but still went sweet on the car

Garret turbo, info in pics, freshly rebuilt but selling as I want to go bigger, offers over 500

Some other random fj bits like dizzy, pistons, injectors, pretty much anything that bolts to the motor

So yeah offers on everything, not real keen on shipping but will if youre not in a desperate rush, would also swap for stuff, I'm after stuff like dry sump gear, fuel cell, need some fabrication done, try me I might be keen

R30_Elliott wrote:Having a bit of a clean up at my shed need to sell this stuff before I get sick of it and dump it

R200 long nose lad with rebuilt axles, was going to keep this as a just in case setup but have cut the subframe mounts out of the car so it's not gonna happen, could probably use a new set of plates but it's still got life in it. Also have dr30 rear lower arms with hubs and crossmember, offers

What ratio? plate lsd im guessing?

Long shot, but I am looking for S12 FJ20ET manifolds (Def exhaust, but inlet too at right price). I have two DR30 FJet exhaust manifolds, but the S12 would give me a little more room away form my firewall.

Any FJ20 rocker covers?

I think it's a 4 or 4.1 ratio, it's from a dr30 originally I believe, I bought it off DJZ on here a couple of years back and only used it for a couple of hundred k before I got the axles reconditioned then decided to make it into a race car. Yes it has plates inside it so I assume it's plate type?

Sorry no s12 bits or rocker covers, I had to get mine welded as the wee boss bits round the side broke

It's an R31 clutch centre in a 280ZX housing, I think it was a 3.7.

What do you want for the inlet manifold?

Would be interested in the diff and half shafts if I can have a look.

Flick me a text on 021985933 if ya want to have a look at it

I've got one bare dr30 manifold but could chuck a throttle body on it and injectors if you need them? It's been semi polished but would look better painted, not after much pretty much make a offer you think is fair and it's yours

There is a guy on the FJ group on Facebook looking for a dizzy.
https://www.facebook.com/groups/fj20et/" onclick="window.open(this.href);return false;

I linked him here too.

Sweet I'm pretty sure I've got 2 of them will have a look tomorrow , cheers mate