New Zealand Datsun Club

Hey guys.
Does anyone happen to have a rear panel cut for a 1200 sedan? The one on my car had been replaced at some point during its life and they did a terrible job. Was gonna live with it but then I thought if I could get one easy enough then I'd weld a new one in...

Try Nissan, I bought one some years ago through Cockrams- you never know they may still have some stock.
Cheers
Dave

Cheers. Will try them tomorrow.
Although, even a second hand cut would suffice

We have the lower rear quarters available at Automotive Panel Craft

so your after the whole rear? tail light holes and all.

Yeah mate. Especially the tail light mount points as that's where the previous cut was severely botched