New Zealand Datsun Club

Anyone got anything?
Don't have to be fantastic condition as i'm probably going to have to cut and shut them a bit too make it all fit in the 1200

how about some factory ones?

here you go nick
http://www.trademe.co.nz/Trade-Me-Motor ... 149928.htm" onclick="window.open(this.href);return false;
http://www.trademe.co.nz/Trade-Me-Motor ... 194899.htm" onclick="window.open(this.href);return false;
http://www.trademe.co.nz/Trade-Me-Motor ... 214449.htm" onclick="window.open(this.href);return false;

Nah factory ones point at the firewall I already threw mine out.
Dylan, seen those s14 ones (the new orange ones), but want to find something cheaper cause i'm not sure how much i'll need to chop up, The other two a FWD sr's so no good either unfortunately. Thanks though

I have dyno'd an s14 with Headers and big exhaust, and then with a standard exhaust system, and believe it or not the factory exhaust was much better, it had about 5 peak HP less, but more overall HP through the rev range.

yeah I won't be going over board. I just can't physically fit the standard cast header on, the outlet flange touches the firewall. I don't really care that much about this motor. This is the $300 cert motor. The next motor will be the "proper' motor