.

[Josh]

FJ, Biatch!

And a Bumper

[Brnwgn]

FJ all the way!!!

[MR1200]

so got my new motor jus givin it a freshin up at the momentnew ring bearing ect
then afta the nats ill get stuck into it just gota a wee but of fab 2 do but i dont
think a ga16 will bee 2 hard too fit
ill post sum pics when its under way!!!

[mint16]

what did the motor cost you dude?
ive been thinking for a while now about this conversion.

[dirtyleppa]

there was a ga16 on trademe not so long ago converted to RWD with twin carbs relatively cheap. what your plans for the new motor?

[mint16]

yeh i saw that, went for 150ish, christ!

[MR1200]

got 2 for free from a mate at the werckers
gota cut a hole in the firewall for the dizzy cut a hole in the front so i can get a bigger
alloy radiator in there and notch the crossmember so i can line the motor up with the box
as i dont wanna make new g/box mounts and so far thats all i think i gota do. so afta the
nats it will b all go!!!!

[mint16]

man what a score!
so the 60a 5spd bolts straight up to the ga16de block?

[MR1200]

yup lookin at it i gotta cut a bit out of the side so i can fit the a seris startermotor and drill an tap an new whole and a hole lota pissin round with an fly wheel and clutch setup

[mint16]

yeh true, i knew the flywheel/clutch issue would be a challenge.