EOI R200CLSD With Axels and 4 Bolt CVs, L4 EFI, R160CLS

[unlimitedpower]

Well the time is drawing nearer for me to paint my car and unfortunately its looking like im going to be short of money.
I have the option to either put it off and save or sell off some of my parts to try fund the project.

I have a R200 CLSD from a Turbo R31 (think its 3.9:1) Comes with axles and 4 bolt CV cups along with the 4bolt companion flanges.

I also have a L4 L18E EFI manifold. (90% Complete) includes ECU, loom, manifold with throttle body airflow meter etc. Its missing the temp sensor housing and sensors. Not a biggy you might be able to use the L6 stuff or its possible it not even needed im not sure.
I did plan on keeping this till mine was running so i could test the ECU and Airflow meter.

Im not going to be letting this stuff go to cheap (but im not out to try rip anyone off) i know both items are hard to find and are desirable.
If you really want it make me an offer via the PM system.

Also for Sale a 3.7:1 Subaru CLSD a bolt in job for the IRS Datsuns you just need to swap over your stub axels i have loosened the torques bolts for the owner as these can be a pain in the arse to undo.
Its very tight and i can't get it to slip by turning the CV joins with my hands (yes i checked its not locked and have photo to prove).

http://www.trademe.co.nz/Browse/Listing ... 61&ed=true" onclick="window.open(this.href);return false;

[nosebleed]

location?

[unlimitedpower]

Valid Point.
Im in Dargaville, Northland.
Id need a week or 2 if i get a keen buyer for the right price. As some of the parts in storage at my parents 45min "1 way" drive away. Unless who ever was picking up wanted to travel that far as a well.