Kitchs 1200 Coupe - road legal!

[Kitch]

Got the steering arms and ball joints fitted up.
temp mounted my new adaptor flange for the ITB's to the dellorto manifold.
Bit tight for fuel rail space, as it fouls a bit wih the throttle linkages, but I have brought some short length injectors which will hopefully create nough clearance.

not much else to report, other than my ECU has just been reconfigured and I now need to sort out my EDIS / ignitor setup, started on fuel system too.

[Bartman]

are they coby D1 headers Kitch? (There may be a D1 stamped on the top edge of one of the flanges) If so make sure that the idler arm doesn't foul when going from lock to lock.

[Kitch]

no idler arm fitted at the moment....
they are my spare headers just hiffed in to ensure didnt foul on the throttles

which should I be after D1 or D2?

[Bartman]

I'm pretty Sure D2's are what I'm running. And they clear the steering. I spent hours trying to mod a set of non clearing ones untill i gave up.

[grant76]

D2's are for twin carb fitment aren't they?? d1 standard carb/manifold

[MR1200]

the single carb onesa are easy 2 modify just a gasplant and a hammer

[Bartman]

some A series header fouls the steering. D2's have nicer shape etc.

[MR1200]

yea i no but bending a bitta pipes cheaper than buying a new set

[Flauski]

Those ITBs are H O R N Y !!!!!

[Kitch]

CAMBER WOO HOO !!!



approx 3 degrees by my calc, thanks in large to 310 lower arms and balljoints and new D2 camber plates that arrvied from the states today