dattoboy's datsun b110 deluxe

[Bartman]

Bout time you busted out some pictures Bede!
If you get your exhaust built in good time, I have a handheld innovate motorsports wideband here. UNless I have to give it back to the guy who I borrowed it off we could give it a whirl on your car to try get a handle on your mixtures. I think it has data logging ability, but I'm not sure how to do that. Be just the ticket for rejetting that carby.
I also have a sweet page bookmarked on water injection too.

[dattoboy]

cheers for the positive comments guys,
exhaust should be done in the next few weeks then onto the tuning.
Sounds good bart will let you know when its all good to tune.

flauski: shes got a bit more rust in her since that picture nothing a couple of weekend with the anglegrinder and welder can't fix.
Once shes all tuned then onto the rust and run it through for a WOF.
hasn't been on the road since 2004 when you had it.

[Kitch]

that looks like a mint setup!

Good work Bede, bet you can't wait to get this on the road

[lewishorrell]

nice carby bede!!!!!!! if you had this one you could intercool it and blow through it!!!! olny prob is it cost me an arm and a leg lol

[lewishorrell]

come to think of it i think i have the original needle out of my carb it is for a mg metro turbo which is 1300cc i could give ya that part number and perhaps that could get ya started or i could open up my carb some time and get ya the number for the needle in it cos its tuned for 12psi so will be way richer then factory

[gingofthesouth]

for the life of me I cant see the fuel injection in the picture

[lewishorrell]

for the life of me I cant see the fuel injection in the picture

thats the idea haha

[dattoboy]

Been a wee while since a update, on Saturday I sorted a boost leak (kept blowing hoses)
Shes now pulling hard (a12 turbo hard haha) but I need to wire up a rev counter and finish exhaust.
Then onto proper tuning hopefully with a wide and then possibly even treat the beast to a dyno run.