Copper washers for turbo banjo bolts.

Datto_610 · Post by **Datto_610** » Sun Jun 12, 2011 2:12 pm

Anyone know where to get the copper washers that go on the banjo bolts for turbo oil lines??? I need 6 and cant find any at repco etc as they only sell a few sizes which arn't the ones i need. Dimensions are O.D 20mm and is I.D 15mm roughly. Any help much appreciated.

85_Z31 · Post by **85_Z31** » Sun Jun 12, 2011 2:48 pm

Datto_610 wrote:Anyone know where to get the copper washers that go on the banjo bolts for turbo oil lines??? I need 6 and cant find any at repco etc as they only sell a few sizes which arn't the ones i need. Dimensions are O.D 20mm and is I.D 15mm roughly. Any help much appreciated.

they are the same type of copper crush washers as used in power steering hard lines, You could try gettign them directly from nissan, or A hydrualics place

I think Steve ( datman310) works for Hydralink give him a pm perhaps

Post by **skdmrx** » Sun Jun 12, 2011 3:36 pm

Hydrolic seals/fittings places or safe-r-brakes have em

Datto_610 · Post by **Datto_610** » Sun Jun 12, 2011 3:57 pm

Cheers guys, i'll look into those options.

DAT620 · Post by **DAT620** » Sun Jun 12, 2011 4:35 pm

blacks fasteners, wilson brothers, saeco, steel and tube?

nick_m · Post by **nick_m** » Sun Jun 12, 2011 4:44 pm

yeah cv specialists have them too but safe r brakes are cheaper.

Datto_610 · Post by **Datto_610** » Sun Jun 12, 2011 4:59 pm

Sweet ill pop by safe r brakes after work tomorrow.

New Zealand Datsun Club

Copper washers for turbo banjo bolts.

Copper washers for turbo banjo bolts.

Re: Copper washers for turbo banjo bolts.

Re: Copper washers for turbo banjo bolts.

Re: Copper washers for turbo banjo bolts.

Re: Copper washers for turbo banjo bolts.

Re: Copper washers for turbo banjo bolts.

Re: Copper washers for turbo banjo bolts.