piece of angle steel

datsunboy · Post by **datsunboy** » Mon Sep 12, 2011 8:27 pm

I need a piece of angle iron.

approx 20x20mm, not fussed on thickness....but less than 3mm would be fine.

I need only about 150mm length (or 2x 75mm lengths).

can anyone help?

Post by **kartboy** » Mon Sep 12, 2011 8:42 pm

I can probably help if you haven't found anything yet. Will just fold up what ever you need at work out of what ever thickness you would prefer.................its not like I have much else to do at the moment.

datsunboy · Post by **datsunboy** » Mon Sep 12, 2011 8:50 pm

Haha, that would be awesome cheers Hayden!

since you've got nothing to do.....

I need them to mount my 2 coil packs on.....coils weight about 300g each, so I would say 2mm steel shoult do it nicely?

two peices at 20x20x75 would be perfect, and if you were bored, then you could also drill some holes in them lol.
2x 6mm holes, 47mm apart, on each angle. (so 8 holes in total)

Dont worry about the holes tho if you dont want.....I do have a drill and a vice lol

Post by **kartboy** » Mon Sep 12, 2011 9:05 pm

where is your work located?? I may even be able to drop them off to you there

datsunboy · Post by **datsunboy** » Mon Sep 12, 2011 9:07 pm

shit, no thats service with style!
Im in Tuam St, between Durham and Montreal St's.

Txt me if you want the exact address

Post by **kartboy** » Mon Sep 12, 2011 9:16 pm

sweet, not to far from me so will give you a text once I have done them.

New Zealand Datsun Club

piece of angle steel

piece of angle steel

Re: piece of angle steel

Re: piece of angle steel

Re: piece of angle steel

Re: piece of angle steel

Re: piece of angle steel