Kitchs 1200 Coupe - road legal!

[unlimitedpower]

Where did you get your Datsun ID plate from? I need a new one.

[classicdat]

Looking great Kitch, loving this build and great to see you progressing toward the long awaited completion.

[Kitch]

cheers for the comments fellas. the plan is to have it fitted out in engine bay
and underneath in next couple of months, may even do some interior stuff
that I can do now.

the datsun firewall plate was made by a company in Auckland,
I had a couple of runs done of them and flicked them off.
Think they were called 'cutting edge' cost a wee bit for setup, but printing costs
were not that bad. that was a few years back I got them done.

[brocky41]

So I guess the panel beater ran out of time before xmas to blow over the outside???

Running gear in then top coat??

Its coming up spectacular thou dude - well impressed.

[kb110]

Unlimited Power
The guy I know that does does perfect copies of any ID plate is Peter Buckley in Tauranga. You can just buy a single plate.
His mobile phone number is: 027 657 6607
Landline: 07 578 7839
From memory they might be $20...

[unlimitedpower]

Thanks heaps for that.
Keep up the good work can't wait to see the finished product.

[darrenwilson]

Nice whats the setup in front? ca18 disc,do you have a pic of how the calipers are mounted from the back?

Cheers Darren.

[Bartman]

They're mounted like this http://www.nzdatsun.com/forums/viewtopic.php?f=17&t=558" onclick="window.open(this.href);return false;

I've been meaning to have another run of plates laser cut for a very long time.

[Kitch]

Spent a couple of hours over the weekend sorting out brakes.
had to reshape some of the hard lines a little bit. My new braided front lines all worked sweet.
few teething problems, with rear cylinders popping their seals and leaking fluid all over the floor
but once I fitted new shoes seem tos ort it out (I think they were extending too far to get shoes to
grab the drum due, to heavily worn pads I was setting up with, and the fact cylinders were new and
drums have been machined).

So I have 'pedal' , and will give them a good bleed out, to get them sorted a bit better when I have
someone here to help me.

some pics for those interested.

[Flauski]

Yummy