How dare u bait me for more low.
On another note. Coupe is emptied out and ready to be dealt to
. Need the rear leaves lowered and resetso will get onto it asap. Reccomendations are needed.Luke's 1200 Coupe
Re: Luke's 1200 coupe of going to keep forever-ness!
I bought them....
How dare u bait me for more low.
On another note. Coupe is emptied out and ready to be dealt to. Need the rear leaves lowered and resetso will get onto it asap. Reccomendations are needed.
How dare u bait me for more low.
On another note. Coupe is emptied out and ready to be dealt to
. Need the rear leaves lowered and resetso will get onto it asap. Reccomendations are needed.1972 1200 coupe KB110
-
braasmonkey
- Site Admin
- Posts: 994
- Joined: Fri Dec 03, 2010 6:19 pm
- aka: Braasy
- Location: Sydney, Australia
- Contact:
Re: Luke's 1200 coupe of going to keep forever-ness!
I recommend you do it...luke wrote:I bought them....
How dare u bait me for more low.
On another note. Coupe is emptied out and ready to be dealt to
1972 DATSUN 1200 (B110) 4 DOOR SEDAN << Check Out My Build Thread
1972 DATSUN 240Z (S30) 2 DOOR COUPE << Check Out My Build Thread
1972 DATSUN 240Z (S30) 2 DOOR COUPE << Check Out My Build Thread
-
Kitch
- Financial Member
- Posts: 1689
- Joined: Wed Aug 20, 2008 9:29 am
- Location: Timaru
- Location: Timaru
- Contact:
Re: Luke's 1200 coupe of going to keep forever-ness!
I used an out fit in Dunedin to reset my rear leaves.
I had them reset 60mm lower with an additional leave added for stiffness.
Currently I have 40mm blocks in and the car sits perfect at the back IMO.
by the time car is fitted out, I expect I will only need 20-25mm blocks to
achieve correct lowness. I can't have too low, as I have my 2 monkeys in
the car most of the time, and don't want it to drag its arse, when I have
stuff in the boot either.
I had them reset 60mm lower with an additional leave added for stiffness.
Currently I have 40mm blocks in and the car sits perfect at the back IMO.
by the time car is fitted out, I expect I will only need 20-25mm blocks to
achieve correct lowness. I can't have too low, as I have my 2 monkeys in
the car most of the time, and don't want it to drag its arse, when I have
stuff in the boot either.
Re: Luke's 1200 coupe of going to keep forever-ness!
bellamy and east are the people to see in chch, they are on falsegrave street at the end of fitzgerald ave
-
Bartman
- Committee Members
- Posts: 7303
- Joined: Sat Jul 19, 2008 9:04 am
- Location: Datsun City
- Location: Christchurch New Zealand!!!!
- Contact:
Re: Luke's 1200 coupe of going to keep forever-ness!
^^^This.
Also, ask them to reverse your leaf eyes. That way you'll keep some of the eliptical shape of the leaves. I bleat on about this endlessly, but I had some flat as fuck leaves once, and they were really really shit. (I couldn't put down any power at all)
Also, ask them to reverse your leaf eyes. That way you'll keep some of the eliptical shape of the leaves. I bleat on about this endlessly, but I had some flat as fuck leaves once, and they were really really shit. (I couldn't put down any power at all)
They don't call me the man with the rubber arm for nothing you know.............
-
Kitch
- Financial Member
- Posts: 1689
- Joined: Wed Aug 20, 2008 9:29 am
- Location: Timaru
- Location: Timaru
- Contact:
Re: Luke's 1200 coupe of going to keep forever-ness!
Good call Bart - thats the one thing I regret not doing with my setup
Re: Luke's 1200 coupe of going to keep forever-ness!
Might be the go for this weekend/tomorrow night then. out comes the rear end again, fuck! i think il go the same way kitch did, resetting about 60-70mm with the added ....leaf?, do the thing bart said too. and il run my 50mm blocks as my rear seat is pointless....... as i assumed yours would be kitch? its tiny back there!
with the resetting thing, if over time the leaves went ....slack? and flat? can they be re-reset? might be a stupid question i dunno.
are bellamy and east open weekends? and would they paint them for me after you think?
with the resetting thing, if over time the leaves went ....slack? and flat? can they be re-reset? might be a stupid question i dunno.
are bellamy and east open weekends? and would they paint them for me after you think?
1972 1200 coupe KB110
-
Kitch
- Financial Member
- Posts: 1689
- Joined: Wed Aug 20, 2008 9:29 am
- Location: Timaru
- Location: Timaru
- Contact:
Re: Luke's 1200 coupe of going to keep forever-ness!
Brown and Cope did mine in Dunedin, and they painted them up for me when they finished, although not up to my standards so had them repainted in chassis black 
Yeah back seat is small, my kids were a lot smaller when I started my build.....
Yeah back seat is small, my kids were a lot smaller when I started my build.....
-
Bartman
- Committee Members
- Posts: 7303
- Joined: Sat Jul 19, 2008 9:04 am
- Location: Datsun City
- Location: Christchurch New Zealand!!!!
- Contact:
Re: Luke's 1200 coupe of going to keep forever-ness!
They might be open on a sat morning.
I'd ring first.
I'd ring first.
They don't call me the man with the rubber arm for nothing you know.............
Re: Luke's 1200 coupe of going to keep forever-ness!
leaves are out and on back of the ute ready for an optimistic drop off tomorrow morning..... pics of proof i actually worked on my car coz none of u would actually believe me otherwise......
THE BEFORE..... big lack of diff and the likes.....PROOF! granted my pic skills are shit as my proof pic shows.... allow me to further prove that by showing off my 2 datsun toys together (same pics as ute thread)....
sunny outside when picturing the ute so why not add this.....
this is where the sun really comes from....
THE BEFORE..... big lack of diff and the likes.....PROOF! granted my pic skills are shit as my proof pic shows.... allow me to further prove that by showing off my 2 datsun toys together (same pics as ute thread)....
sunny outside when picturing the ute so why not add this.....
this is where the sun really comes from....
You do not have the required permissions to view the files attached to this post.
1972 1200 coupe KB110