I have a Datsun 910 that I'm working on, it has the L20B engine. The carburetor has been causing issues, so it's a good excuse to convert to EFI.
I was thinking that I could get a second-hand manifold from a more recent nissan, but I'm not sure what would fit. SR20? maybe a CA18? I have no idea.
Any advice?
Picture related
Datsun 910 Project, EFI conversion advice?
-
- Newbie
- Posts: 2
- Joined: Fri Mar 01, 2013 12:30 pm
- Location: Tauranga
Datsun 910 Project, EFI conversion advice?
You do not have the required permissions to view the files attached to this post.
Re: Datsun 910 Project, EFI conversion advice?
L18E has a manifold that will fit, I think datsunboy is using one with a CA18 computer and Nistune. Or you could buy those sweet throttle bodies that go onto Weber style manifolds if you have lots of $$$
Re: Datsun 910 Project, EFI conversion advice?
L18e manifolds wont fit l20b unless you drill new manifold studs and drill slots in the inlet ports for injectors,
IMO a good set of twin su carbs are a great upgrade without going all out, start and run awsome and are reasonably cheep, i know it's not injection but its an option
IMO a good set of twin su carbs are a great upgrade without going all out, start and run awsome and are reasonably cheep, i know it's not injection but its an option
-
- Newbie
- Posts: 2
- Joined: Fri Mar 01, 2013 12:30 pm
- Location: Tauranga
Re: Datsun 910 Project, EFI conversion advice?
http://www.trademe.co.nz/motors/car-par ... 656095.htm" onclick="window.open(this.href);return false;
Would something like this work?
Would something like this work?
- brocky41
- Financial Member
- Posts: 1764
- Joined: Sat Jul 19, 2008 11:05 am
- aka: Brocky
- Location: Christchurch
- Contact:
Re: Datsun 910 Project, EFI conversion advice?
Hi - you could always try an LD20 diesel manifold - see pic below - mine splits at the u turn so you could run a custom plenum on top or use the whole thing with a throttle body mounted to the front.
heaps of room for injector bosses and fuel rail etc - it may not bolt straight up to head but would be very close - they came out in some diesel vanettes largos and serenas etc aswell
This ones in my r30 wagon
Uploaded with ImageShack.us
heaps of room for injector bosses and fuel rail etc - it may not bolt straight up to head but would be very close - they came out in some diesel vanettes largos and serenas etc aswell
This ones in my r30 wagon
Uploaded with ImageShack.us
Re: Datsun 910 Project, EFI conversion advice?
Should, just needs an air cleaner for itBluebird910 wrote:http://www.trademe.co.nz/motors/car-par ... 656095.htm
Would something like this work?