1974 B110 Project!

[Adam Herbert]

Bought this 1974 1200 from Wellington about 2 weeks ago. Just Been driving it around as stock for the time being. Planning to treat him to a new paint job soon, and drop a Supercharged A15 in.

[Adam Herbert]

Stock Engine Bay with A12

[Adam Herbert]

Bought some new 13 inch Minilite mags. 7inch wide for the front, and 8inch wide for the rear.

[b110sss]

Hate to spoil your enthusiasm but those wheels are too big for the 1200 sedan without some very serious rear guard pruning and flaring, made even worse if you lower it.
Thats the wheel size that one would expect to see on a ShellSport race car.
13x6 with a 175x60x13 ( 185 at a pinch with liberal use of a hammer on the rear arches ) is really it.
Cheers
Dave

[Adam Herbert]

I was aware that I was going to have to flare the guards, thats not an issue tho.

[buzzy]

The rears might rub on the inside to mate, they have a step inside the lip that causes the tyre to rub

[mitey1200]

looks very tidy and personally love the wheel choice. ive always had a soft spot for Minilights

[Bartman]

Glad you finally found a car Adam.
When you test fir your blower engine in the hole you'll see what I meant about the header collector and the idler arm on the passengers side chassis rail.
Looks like a nice car. I'm looking forward to the updates on this build thread.

[Adam Herbert]

The firewall slants back on a 45 angle, so I was thinking I could avoid the idler arm by just having the pipes come really close to the firewall, shifting around the transmission. and having the collector further down the pipes a bit.

[my1200]

Dont Flare it ! do that to one with a heap of rust.. just my personal thought