my sedan

buzzy · Post by **buzzy** » Thu Aug 14, 2014 8:12 pm

pic to try and get motivation!

buzzy · Post by **buzzy** » Sun May 31, 2015 3:59 pm

Finally done something on the sedan after it just sitting there for awhile. managed to get the rear sitting about right. Ute diff is off getting mounts made up then can put that in. Once diff is in, then I can sort d/shaft. Should slowly have more progress on this.

pic for motivation

kobyn · Post by **kobyn** » Mon Jun 01, 2015 5:09 am

Mean u didn't sell it man keep chipping away it'll b worth the wait

Sent from my iPhone using Tapatalk

buzzy · Post by **buzzy** » Tue Aug 04, 2015 6:18 pm

Ute diff is now in. Drive shaft getting made over the next couple of weeks. Will start the search for a fuel cell, then look at getting the engine rebuilt!

pic for thread

bambam118 · Post by **bambam118** » Tue Aug 04, 2015 6:37 pm

looking good would love to see in the flesh

Naki-Fisher · Post by **Naki-Fisher** » Tue Aug 04, 2015 8:17 pm

Are you after a fuel cell or a standard fuel tank?

Post by **twin120ys** » Tue Aug 04, 2015 8:36 pm

This thing is sexy.

buzzy · Post by **buzzy** » Tue Aug 04, 2015 9:03 pm

Naki-Fisher wrote:Are you after a fuel cell or a standard fuel tank?

Fuel cell as I need to run bigger fuel lines to feed the carb, the little Datsun ones wont be up to the task

kobyn · Post by **kobyn** » Wed Aug 05, 2015 5:19 am

Surge tank ?youll need one then to bro

Sent from my iPhone using Tapatalk

Post by **Bartman** » Wed Aug 05, 2015 9:41 pm

I fitted a 3/8 pick up into the bottom of my fuel tank. That and a 3/8 supply line cured a 6000rpm lean out I was suffering from.

New Zealand Datsun Club

my sedan

Re: my sedan

Re: my sedan

my sedan

Re: my sedan

Re: my sedan

Re: my sedan

Re: my sedan

Re: my sedan

my sedan

Re: my sedan