WTBorrow: 350z clutch alignment tool

[nzbidzel]

anyone have one or access to one for me to borrow? want to see if vr6 clutch has the has spine as a 350z clutch, so i can work out how to mate these parts with which clutch

it helps me to think of the engine as the great grand daddy to the bugatti veyron's

lol im puting bugatti veyron engine into the datto

[DJZ]

Clutch Industries catalogue says no, 350Z is 24 teeth by 25.5mm, looks like most of the VR6 clutches are 28 teeth by 22.1mm.

[nzbidzel]

cheers, i couldnt get a hit googling the 350z clutch. now to work out

sell the button clutch i have for the vr6, and get a 350z clutch make it work for the vr6 block
or make the vr6 clutch work for the 350z gearbox spline
or other

[DJZ]

What diameter clutch does the VR6 flywheel take? If it's around 240 - 250mm then you could possibly run a Nissan plate in the VW clutch if the thickness is similar.

[nzbidzel]

What diameter clutch does the VR6 flywheel take? If it's around 240 - 250mm then you could possibly run a Nissan plate in the VW clutch if the thickness is similar.

Ill pull off the gearbox from the test cradle setup i have in next day or two and measure up the vr6 flywheel as i dont know off hand, its a lightened 12lb unit, the engine without a gearbox is 300mm ID of the bellhousing flange so 250mm could be good