needle in a haystack

ginga-dato · Post by **ginga-dato** » Tue Jan 27, 2015 7:15 pm

i know this is a mega long shot but does anyone happen to have any taiwanese front guards for a b210 that are sitting around and arent going to be used? my factory ones are rather shot and the front left has been in a collision and had a crap repair. i repaired the rust in the drivers side guard but struggled quite a bit with the shapes and curves and then went to start on the left guard and found that its in worse condition so i put them on hold. even if someone has a set of good conditioned, don't have to be perfect, factory guards would be awesome. any help would be appreciated greatly

cheers

Post by **tlssunny** » Wed Jan 28, 2015 1:54 pm

the amazing greg had a gaurd for sale not long ago, unsure of what side etc but it would be worth a go, theres a place in hamilton that do fibreglass ones, then you wouldnt have any rust EVER!!!!!! you just have cracked paint work

ginga-dato · Post by **ginga-dato** » Wed Jan 28, 2015 3:54 pm

I had a look at gregs guard and it was full of bog and badly done rust repairs. Dont want to go fibreglass either cos it will crack too easily with the rim fitment that I'm gona go for

kobyn · Post by **kobyn** » Wed Jan 28, 2015 8:55 pm

I found a brand new one at the waipukurau wreakers like 7years ago and they had two lfts stashed way up in the rafters ,try ya luck there it might still b there I rang every wreakers within a 2hr drive to find it

Sent from my iPhone using Tapatalk

ginga-dato · Post by **ginga-dato** » Wed Jan 28, 2015 11:30 pm

Cheers man. Will definitely give them a ring

New Zealand Datsun Club