L series valves..........

Post by **Bartman** » Wed Sep 02, 2009 9:07 pm

I'm looking for some 42mm L series inlet valves. I'd consider a whole head or even a whole motor so long as the price is right.

2 doors · Post by **2 doors** » Wed Sep 02, 2009 9:25 pm

Ive still got that z18 head here, not sure if its what your after, but if it is then its yours.

Post by **Bartman** » Wed Sep 02, 2009 9:29 pm

what size are the inlets mate?

Datto_610 · Post by **Datto_610** » Wed Sep 02, 2009 9:31 pm

The motor in my bluebird is all yours, but think it could be an L20.

Post by **Brnwgn** » Wed Sep 02, 2009 9:34 pm

buy new

Post by **Bartman** » Wed Sep 02, 2009 9:38 pm

WOW! Ask and you shall recieve

Datto_610 · Post by **Datto_610** » Wed Sep 02, 2009 9:40 pm

Lol yeah prob best to whip the head off rather than give you the motor just in case they the wrong size.

dirtyleppa · Post by **dirtyleppa** » Wed Sep 02, 2009 10:12 pm

the head in your bluebird greg should just be sitting there, would take about 10 min to get here out

datsunboy · Post by **datsunboy** » Wed Sep 02, 2009 10:49 pm

bart......I bought brand new 44mm L6 valves for my old L20B....cost a wopping $8 each

thats only $32 for brand new 44mm inlet valves

torqued · Post by **torqued** » Thu Sep 03, 2009 7:57 am

barts too much of a tight arse for that sorta money

New Zealand Datsun Club