Datto_610's C31 Laurel Pillarless Sedan

broke · Post by **broke** » Fri Jun 26, 2015 12:31 pm

You'd need the 6 cyl kit, I just posted that as an example - it's the same Stealth/Accuspark type that I put in the Crown.

torqued · Post by **torqued** » Fri Jun 26, 2015 1:06 pm

I agree with John in regards to using a 6cly kit rather than a 4cly one

broke · Post by **broke** » Fri Jun 26, 2015 2:03 pm

DJZ wrote:
Datto_610 wrote:Tell me the bits I need and I'll think about it....
You can find what you really need right here:

http://www.trademe.co.nz/motors/car-par ... 896943.htm

I think it would go really well with one of these Dan..

twincam.jpg

http://forums.hybridz.org/topic/119641- ... tsunworks/" onclick="window.open(this.href);return false;

Datto_610 · Post by **Datto_610** » Fri Jun 26, 2015 6:16 pm

Lol stop spamming my thread with things that I'll never buy for this! Buy it off me John and all your 6cyl L series dreams can come true!

Datto_610 · Post by **Datto_610** » Mon Jul 06, 2015 10:27 am

Ok so this happened last night not very impressed at all sigh... I knew I should've had a look at it sooner!! Anyone got a spare rear half shaft handy???

broke · Post by **broke** » Mon Jul 06, 2015 1:05 pm

Didn't DJZ offer you a 280ZX one? I've got 510 ones but unsure if they're going to work for you.

Datto_610 · Post by **Datto_610** » Mon Jul 06, 2015 8:31 pm

Yeah he did but that would be a short term loan kinda thing. I would like to get it fixed permanently. I unboltd the axle from the companian flange and popped out the stub from the diff. Really did a number on the uni joint......

The yoke seems to be pretty scored so may not be able to put in a new uni??

DJZ · Post by **DJZ** » Mon Jul 06, 2015 8:40 pm

I've got one you can have, it's a left one that you broke?

Datto_610 · Post by **Datto_610** » Mon Jul 06, 2015 10:18 pm

Yeah left hand side. If you could that would be really good!

Post by **Bartman** » Tue Jul 07, 2015 9:30 pm

New uni joint shouldn't cost much.
R180 UJ input yolk might be a bit harder to find.
I'd say that joint has been fucked for ages. Although the max slam angularity will have sped up it's demise fo sho.

New Zealand Datsun Club