310 or 1200 ute steering bits
Re: 310 or 1200 ute steering bits
whats so good about putting these "bigger" ones on ya b110?????????? to me it seems abit of a waste as you will spend 300-400 on just b310 parts
-
Tony.buchler
- Datsun Dreamer
- Posts: 174
- Joined: Sun Mar 24, 2013 8:22 pm
- aka: Tbag
- Location: Orewa, Auckland
- Contact:
Re: 310 or 1200 ute steering bits
Good point. I was under the impression the 310 ball joints were stronger and gave negative camber off the bat meaning less camber needed on the camber plate. Also the castor rods would provide more adjustment than the 110 rods?
If this is a whole lot of bs then I'd much rather keep the original parts I already have painted and bushed ready for installation...
If this is a whole lot of bs then I'd much rather keep the original parts I already have painted and bushed ready for installation...
-
Bartman
- Committee Members
- Posts: 7303
- Joined: Sat Jul 19, 2008 9:04 am
- Location: Datsun City
- Location: Christchurch New Zealand!!!!
- Contact:
Re: 310 or 1200 ute steering bits
The longer BJ gives free negative camber.
They don't call me the man with the rubber arm for nothing you know.............