Parts for H230 260c

Post by **tlssunny** » Tue Nov 10, 2015 4:05 pm

WHAT AKAROA PHOTOS???

Post by **tlssunny** » Tue Nov 10, 2015 4:08 pm

don't worry just found them

Dattodevil · Post by **Dattodevil** » Tue Nov 10, 2015 4:33 pm

Haha, they're coming, already done quite a bit of work to it

Sent from my LT26w using Tapatalk

Dattodevil · Post by **Dattodevil** » Wed Nov 11, 2015 7:15 am

Also looking at getting modified bump stops made if anyone else wants any

Post by **brocky41** » Wed Nov 11, 2015 10:54 am

I just cut mine down and rounded them off lol, you know what springs etc to use?

Dattodevil · Post by **Dattodevil** » Wed Nov 11, 2015 12:37 pm

I've taken 1 coil out to stiffen slightly, will compress the rest.

Sent from my LT26w using Tapatalk

Post by **brocky41** » Wed Nov 11, 2015 9:20 pm

I found the super low 6 cylinder HQ holden fronts from either King or Cobra go straight in (have done a couple times now)

Lowers front by 60mm and use a 2 inch block in the back (or reset 2") and the sills sit perfectly even (tend to sit high in the front with factory coils.

Good time to throw in new shocks too - just use the HQ items again (shorter than original)

Post by **brocky41** » Wed Nov 11, 2015 9:23 pm

Dattodevil wrote:Also looking at getting modified bump stops made if anyone else wants any

Those bump stops hold your lower Ball joint in too - will you be making a whole new unit? Could be keen

Dattodevil · Post by **Dattodevil** » Thu Nov 12, 2015 7:38 am

yeah, working out the best size to take them down to, probably around 25mm off standard.

New Zealand Datsun Club

Parts for H230 260c

Re: Parts for H220 260c

Re: Parts for H220 260c

Re: Parts for H220 260c

Re: Parts for H220 260c

Re: Parts for H220 260c

Re: Parts for H220 260c

Re: Parts for H220 260c