Jays 1973 datsun 1200
-
- Site Admin
- Posts: 994
- Joined: Fri Dec 03, 2010 6:19 pm
- aka: Braasy
- Location: Sydney, Australia
- Contact:
Re: Jays 1973 datsun 1200
Damn those rims look sexy!
1972 DATSUN 1200 (B110) 4 DOOR SEDAN << Check Out My Build Thread
1972 DATSUN 240Z (S30) 2 DOOR COUPE << Check Out My Build Thread
1972 DATSUN 240Z (S30) 2 DOOR COUPE << Check Out My Build Thread
Re: Jays 1973 datsun 1200
hey man, ride is looking killer.
just wondering with your caliper set up - have you had the brake lines made up yet? if so, where did you go, how mucka?
Also, did you keep the left hand (and vice versa) donor caliper on the left hand side of the car...therefore keeping the pipework/ lugs facing down? see photo below...
I have just installed my set up, and about to get the lines made up...but it would seem easier if the caliper lugs/ lines were facing up.
wondering if it's a simple swap from l/h caliper to right etc, or not. I'm going to keep the original flexi line to strut, then have another short flexi made up (I'm running original struts, no mods).
how did you set yours up?
btw, the rotors look huge with my 14s...must look rediculous with your 13s!!
cheers
SMP
just wondering with your caliper set up - have you had the brake lines made up yet? if so, where did you go, how mucka?
Also, did you keep the left hand (and vice versa) donor caliper on the left hand side of the car...therefore keeping the pipework/ lugs facing down? see photo below...
I have just installed my set up, and about to get the lines made up...but it would seem easier if the caliper lugs/ lines were facing up.
wondering if it's a simple swap from l/h caliper to right etc, or not. I'm going to keep the original flexi line to strut, then have another short flexi made up (I'm running original struts, no mods).
how did you set yours up?
btw, the rotors look huge with my 14s...must look rediculous with your 13s!!
cheers
SMP
You do not have the required permissions to view the files attached to this post.
Looking for a 510 at the mo
lost loves
1x KB110 - recently gone to a good home
2x P510 Deluxe
1x P510 SSS
1x P510 Wagon
lost loves
1x KB110 - recently gone to a good home
2x P510 Deluxe
1x P510 SSS
1x P510 Wagon
Re: Jays 1973 datsun 1200
Thanks mate I'm running my calipers with bleeder to the top and lugs to the top
Haha yeh the only just clear the 13s
Haha yeh the only just clear the 13s
Re: Jays 1973 datsun 1200
The car finally has seen the light after four months on axle stands
Looks awesome with her new shoes on to
Looks awesome with her new shoes on to
You do not have the required permissions to view the files attached to this post.
-
- Datsun Nutter
- Posts: 397
- Joined: Fri Aug 01, 2008 6:17 pm
- aka: Bede
- Location: Christchurch, Timaru
Re: Jays 1973 datsun 1200
Wow that it looking good man!
Re: Jays 1973 datsun 1200
looks nice man!
what shock are you running in the back?
what shock are you running in the back?
Re: Jays 1973 datsun 1200
Thanks guys
They are holden Gemini rear shock will try find the part numbers for you
They are holden Gemini rear shock will try find the part numbers for you