L28 blow through tubo.
- gman
- Financial Member
- Posts: 298
- Joined: Sat Oct 06, 2012 4:57 pm
- aka: gman
- Location: christchurch
- Contact:
Re: L28 blow through tubo.
The main differences are in getting them to seal under boost and in getting the carbs to equal the boost fast enough and the way OER and HKS have dune it the carbs get up to boost presser before the runners.All the gasket faces have a raised ring around them to stop the gaskets from being pushed out under boost o rings on every thing fuel level and exsalrator pump all adjusts from out side at the top so you don't have to rip them apart to make fine adjustments . Floats are solid so they don't crush and the fuel float bowl and needle bowl have there own presser equalizing source .
You do not have the required permissions to view the files attached to this post.
- mitey1200
- Datsun Dreamer
- Posts: 136
- Joined: Sat Jul 19, 2008 11:24 am
- Location: Christchurch
- Contact:
Re: L28 blow through tubo.
Aw good to know. I bought some turbo gasket kits and dellorto top hats off eBay and seem to be holding up. Only 9psi at the moment but no dramas yet.
What boost are you planning on running?
What boost are you planning on running?
- gman
- Financial Member
- Posts: 298
- Joined: Sat Oct 06, 2012 4:57 pm
- aka: gman
- Location: christchurch
- Contact:
Re: L28 blow through tubo.
Well my son is going to race this one so it will go out on 10psi then 16psi if we have to.
- gman
- Financial Member
- Posts: 298
- Joined: Sat Oct 06, 2012 4:57 pm
- aka: gman
- Location: christchurch
- Contact:
Re: L28 blow through tubo.
I got time to do weld the wastgate flange on today came up alright
You do not have the required permissions to view the files attached to this post.
Re: L28 blow through tubo.
Holy crap, that's beutifull .
Re: L28 blow through tubo.
One word, wow!
- gman
- Financial Member
- Posts: 298
- Joined: Sat Oct 06, 2012 4:57 pm
- aka: gman
- Location: christchurch
- Contact:
Re: L28 blow through tubo.
Turbo and wastgate all back together.
You do not have the required permissions to view the files attached to this post.
- gman
- Financial Member
- Posts: 298
- Joined: Sat Oct 06, 2012 4:57 pm
- aka: gman
- Location: christchurch
- Contact:
Re: L28 blow through tubo.
Bolted up turbo and wastgate along with plenum to make shore the clearances are all good . Just a 20mm spacer between the manifold and tubo needed.
You do not have the required permissions to view the files attached to this post.
Re: L28 blow through tubo.
Thats awesome