New Zealand Datsun Club

ive got a stainless grill pm me if you keen

This is the plastic grill mounting points, which can be seen on the top of the radiator support panel and on the bottom of the front apron/valance.



And then the metal grill mounts, which can be seen on the inside of where the headlights go.

Cheers yall 4 all the tips, I will flick out a few PM's n txts. So r there only 4 mount points for the stainless grille? In the pic of the stainless grille on the 1st page it looks like there are metal flares or rings around the lights, are they attached to the grille or r they separate pieces? If separate how do they attach?

jas1200 wrote:You should able to get the grill and the rest of the bits you need by asking around and keeping an eye on trademe, I have the parts you need but want them for my own project. Are you going to put a crome bumper on it aswell?

I was thinkn i may run it without the bumper, or jst tidy up my existing 1 n remove plastic ends, i may look at gttn a chrome 1 at sum stage tho. mmm Bit undecided as yet

I like the look without a bumper, also saves some weight. This is my car

Im pretty sure the headlight surround mounts into the square hole, with one of those little plastic thingies.........



The surrounds use's two on the radiator support panel and the other side mounts to the guard....(Picture is of the LH side surround)

Cheers 4 the tips n pics, they do look cool with the frnt bumper off, shame that the number plate covers part of those mean vent slots tho. Spose i cud try make up a num plate in sticker form instead- mite gt sum slightly smaller blinkers too, they look a lil 2 big with the bumper off