Re: Kierans 160jsss coupe project.
Posted: Mon Feb 18, 2013 5:51 am
Not with a R30 gearbox you won't, Out of interest is yours the 2 piece drive shaft or the single piece?
New Zealand Datsun Club
http://www.nzdatsun.com/
https://datsun.co.nz/forum/
Kierans 160jsss coupe project.
Page 2 of 2
Re: Kierans 160jsss coupe project.
Posted: Mon Feb 18, 2013 12:49 pm
2 did they come in 1 piece?
Re: Kierans 160jsss coupe project.
Posted: Mon Feb 18, 2013 9:20 pm
Yip sure did. The 3 cars i have had over the years have all had a single piece shaft fitted. I thought that was the only way they came wasn't till later i learnt that the two piece shaft is actually more common.
Re: Kierans 160jsss coupe project.
Posted: Sun Mar 03, 2013 12:48 pm
It was like christmas when this arrived I love trademe.
Re: Kierans 160jsss coupe project.
Posted: Sat Sep 14, 2013 6:49 pm
After siting at the sandblaster for a month they finally got round to doing it good to see progress
Re: Kierans 160jsss coupe project.
Posted: Sat Sep 21, 2013 9:29 pm
Yum.
And thats a 240K steering wheel you have there right?
And thats a 240K steering wheel you have there right?
Re: Kierans 160jsss coupe project.
Posted: Sun Sep 22, 2013 10:38 am
Sure is Tony I have one too! Looking good man!
Sent from my GT-I9300 using Tapatalk 2
Sent from my GT-I9300 using Tapatalk 2
Re: Kierans 160jsss coupe project.
Posted: Mon Oct 21, 2013 8:40 pm
Epoxy primed after sandblasting.
Re: Kierans 160jsss coupe project.
Posted: Mon Oct 21, 2013 10:29 pm
Who did the stripping of paint etc
Re: Kierans 160jsss coupe project.
Posted: Wed Oct 23, 2013 9:21 pm
I sanded the large flat panels just with the orbiter and gemco did the sandblasting they did a good job but you need to keep on there case otherwise they would take months to do it. It was low pressure walnut or something like that type of blasting.