New Zealand Datsun Club

nzdatman wrote:very nice. what pistons did you use? must be 78mm bore?

Pistons are 4mm oversize

classicdat wrote:Looks good, Nice to see another one getting the A Series treatment. Be good to see some more pics. How does it run?

Shes running great! Just bedding in the engine at the moment, another 400kms or so to go before i can do some power runs on the dyno and give the carbs a tune up. Will post full details once i do this and some more photos

tlssunny wrote:how'd you get it too 1330cc?????????

I didn't do the work myself but the guy who did is a legend. Apparently with 80mm pistons you can bore it all the way out to 1400 assuming the block can handle it.
http://datsun1200.com/modules/mediawiki ... nd_Stroked" onclick="window.open(this.href);return false;