Page 17 of 30
Re: Datsun 260c
Posted: Sat Mar 08, 2014 7:47 pm
by Ivan
Fitted the JDM taillights today.I think they look much better than the Aus/NZ type.Not bad for a $150 shipped.Gives it a more Nissan look.Webbers need tuning But building stoker motor anyways.
http://www.youtube.com/watch?v=gOHNQMZ9wqM" onclick="window.open(this.href);return false;
Re: Datsun 260c
Posted: Sun Mar 09, 2014 1:57 pm
by 2 doors
oh god that is beautiful
Re: Datsun 260c
Posted: Tue Mar 11, 2014 10:48 pm
by Ivan
Bit of a scare today.Finished work today and was driving to my GF place.One of the bolts on the end of the steering box fell off and lost steering to the car.God i was lucky i wasn't feeding it.Luckily i had some wire in the car and was able to do a dogey as repair and limped her back home. Hoping to hear about my block tomorrow so fingers crossed.
Re: Datsun 260c
Posted: Tue Mar 18, 2014 10:38 am
by Ivan
Gutted i can't use my L26 block for my L31 build.Does any one have a spare L28 block or where i could get high compression pistons to suit an L28..so does any one want to buy some HKS 89mm pistons?
Re: Datsun 260c
Posted: Tue Mar 18, 2014 12:40 pm
by 2 doors
is there anything wrong with the l26 block ?
Re: Datsun 260c
Posted: Tue Mar 18, 2014 1:02 pm
by Ivan
Not that i know of,Anyways I'll see if L26 can be stroked out to suit L28 pistons and buy some high compression pistons to suit.
Re: Datsun 260c
Posted: Sat Mar 29, 2014 10:22 am
by Ivan
Nothing to do with my build really.But make's a awesome photo,Karls H330 at my place.Picking up the rest of the H330 i was wrecking.Hopefully it does him well.
Re: Datsun 260c
Posted: Sat Mar 29, 2014 11:45 am
by Datto_610
Woo Cedric party!
Re: Datsun 260c
Posted: Sat Mar 29, 2014 9:13 pm
by Bartman
All class!
Re: Datsun 260c
Posted: Mon Jul 21, 2014 2:00 pm
by Ivan
So many of you guys know that Rich wrecked out a H230 2door.I got some parts out of it and one of the main bits I have been after since owning is car was the factory steel radiator shroud.Thanks to Rich I now have one.Getting it ready for paint.Also getting these rims as well.Car will be off to my mate's place to get the rest of the panel work done and also building the stoker motor too.