New Zealand Datsun Club

Ute today got new hood lining fitted, front and rear window put back in and now at rapid for a good amount of attention. Hopefully be back in a month or so and will get some finished pics

Got a little bit of an update on the ute, The front mount and intake are all finished and the exhaust has now been finished. little bit of a clearance issue with the exhaust as it only has 80mm clearance at the most only just sliding over rapids hoist. seats are sorted and rearing to go in.

I don't supose you could take a picture of the clearance between the drag link, and the sump could you?

Bartman wrote:I don't supose you could take a picture of the clearance between the drag link, and the sump could you?

When I checked it out Bart when I put it in there was plenty of clearance if that's what you are worried about?

On the seppo forums a guy welded up the tapered holes in his drag link, and reamed them in reverse to hang the drag link underneath. Such a mod is the epitome of not legit according to our laws.
I do like the idea of being able to sling the engine lower in the bay though.

Just a few more photos of progress

Nice looking good bro. Hopefully I'll be able to check it out Friday when I'm down that way!

Wow this has come a LONG way since I first bought it

Sorry, for some of the rust repairs done to the Body mounts .............






Keep up the wicked damn good work!

So want another 620................

Did it have the ca in it when you had it man? or was that after your ownership? looks pretty clean and tidy in those pics! definitely changed a bit since then haha

na still had the dirty J motor in it lol.
Was so mean for cruising round.