Braasy's Datsun 1200 (B110) 4 Door Sedan

[gingofthesouth]

Hey Brassy
Also move car inside and subaru out.

[braasmonkey]

Hey Brassy
Also move car inside and subaru out.

Once real work is a go I am hoping to put the vehicle into storage off-site, to keep it more safe, secure, and have a place to work on it. As it is, can't do much work in our poky single car garage or outside due to space constraints.

[crustywhip]

You are in IT aye Brassy?

Maybe its the strong arm thats the problem

[braasmonkey]

You are in IT aye Brassy?

Maybe its the strong arm thats the problem

Yeah, I'm in IT. Whip yo ass any time with my strong geeky arms... I ain't no skinny ass, glasses wearing nerd crusty Hopefully power bar option works out tomorrow morning... PISS OFF RAIN!

[classicdat]

What part of town you in? I'm in Mairehau and have a good bit of pip you can borrow if that is close to your part of town. Try giving the wheel nuts a smack with a hammer directly on the end to shock the threads, before you try turning them, this can make them easier.

[nick_m]

stand on the end of the power that normally does it

[braasmonkey]

So, after nearly a week of starting, finally managed to get the wheels on. Numerous pictures are as follows:

22042011021.jpg

22042011025.jpg

22042011026.jpg

22042011027.jpg

22042011030.jpg

22042011031.jpg

22042011039.jpg

22042011043.jpg

22042011053.jpg

22042011054.jpg

22042011057.jpg

22042011058.jpg

22042011060.jpg

22042011066.jpg

22042011074.jpg

22042011076.jpg

22042011078.jpg

22042011080.jpg

22042011084.jpg

22042011085.jpg

They look pretty sweet. Now that that is all done, can hear that something is rubbing. Was going to take her for a test ride after a few months of non-use and the hopes of a WOF and Rego tomorrow. Sadly the sun is going down so won't be able to check it out till tomorrow however it doesn't quite sound like rubber on metal or metal on metal. Hopefully it's nothing major but was sure the fitment should have been fine. I did notice however that the car appeared to have been lowered a little when I first purchased it, perhaps some new suspension or some spacers may be required.

If anyone has a garage pit, hoist or ramps, I'd be keen to get under her properly. Otherwise, might see if any mechanic types might be available to troubleshoot further onsite. First things first though...car wash

Regards,

- Braasy

[dirtyleppa]

hey man, car looks sweet on the rims. if you want, i can give you a hand with having a look at it. go a jack and some stands handy, and always keen to help out. flick me a txt if you want a hand

[braasmonkey]

What part of town you in? I'm in Mairehau and have a good bit of pip you can borrow if that is close to your part of town. Try giving the wheel nuts a smack with a hammer directly on the end to shock the threads, before you try turning them, this can make them easier.

Cheers for the offer Sorry about the late reply but missed your post. Anyhow, I am based in Addington so not quite round the corner

Regards,

- Braasy

[braasmonkey]

hey man, car looks sweet on the rims. if you want, i can give you a hand with having a look at it. go a jack and some stands handy, and always keen to help out. flick me a txt if you want a hand

Is a bit late now but will do later on today Looks very nice on the rims from both the side and rear, just needs more clean, less rust, more work! lol