New Zealand Datsun Club

Hahaha cheers boys, im trying to just keep on truckin on it. want it going asap. I will try and do as much as i can before the money side of it takes over, then it will be a waiting game. Still plenty to do before then though

Good times lastnight dude.Great to see the ute moving Get a video up!
Heres a lil something to check out

http://www.cardomain.com/ride/706389" onclick="window.open(this.href);return false;

I've got one for ya

Like its making sweet, sweet love to the ground.
Youd be rapt!

lookin good bro. Keen to see more updates

ok, Finally got some more updates. Got my hubs and adaptor plates for my brakes back from john and did a test fit of the turbo r33 front brake setup and then fitted my new wheels to check clearance. They all fit perfectly with only minor inner fender rub because it goes so low. also started making my own steam pipe extractors to move turbo foreward away from the firewall as i have reset the motor into the firewall. Got all the bends and bits i needed for $59incl, i was stoked that it was so cheap. Came out pretty well so far. Here are some pics.


john fancy adapter to bolt the rotor to my hub


My new wheel and brake setup


Floor cut out to fix rust


set of extractors im making

Mean nuggs - hey where can i get one of those Phillanges haha...

Also agree you mush build car/ute around wheels as those are sik for a SIK521

where did you go to get the steampipe bends? they are the ducks nuts

those wheels suit the truck something fierce

and that manifold is

Got the steam pipe bends from a place called Taylors on fitzgerald end of tuam st. I got some leftovers if you want some wal. Yeah i like the wheels to and have to make the rear wheels fit as they are 18x9.5. This means i have to chop the whole rear of my ute off and make a new box section rear with narrowed chassie rails so that i wont have to flare the deck to clear my wheels. Alot of work but its worth it. I will make a start soon on that.