Chops 1200 Ute

[chopper]

Ive been building this ute for about 8 months i guess and is getting closer and closer ive added a few pics of what ive done,ive also done all the work myself after hours down at the shop.

DSCF4182.JPG

DSCF4189.JPG

DSCF4192.JPG

DSCF4908.JPG

DSCF4910.JPG

DSCF5021.JPG

DSCF5062.JPG

DSCF5067.JPG

DSCF5128.JPG

DSCF5143.JPG

DSCF6317.JPG

DSCF6316.JPG

DSCF6361.JPG

DSCF6360.JPG

[Dattochriswagon]

Loving the rear tray swaging !!!
and amazing fabrication!

[bent 1200]

shit yeah loving the tray as well

whats the plans?

[chopper]

just have to finish off the rear tray and stitch on the rear quarters when they arrive from over seas, and then just drive it round with a nice panel & paint few mods and keep the 1200cc motor which is a real mint runner, but either this year or this time next year ive got a lil suprise going in under the hood but wont say anymore about it untill i take the ute off the road again.

I also will be selling when it comes off the road again further on in the year:

Mint a12 motor
with all new seals and gaskets,
new leads and plugs
new clutch and machined flywheel
4speed gearbox
Custom Alloy radiator with electric fan
All new suspension, ball joints,tie rod ends,sway bar rubbers, basically everything that has to do with front engine crossmember and steering.
New sunny struts with disk brakes
shortend struts and compressed superlow springs 2" lower than super low springs all captive and ride height perfect
1200 ute rear diff with lowering blocks.
but ill post it up later on down the track.

[DylPhil7]

"Sicker Than AIDS" as Ginge would say