New Zealand Datsun Club

I'm moving out in 2 weeks so think its time for a clear out. Have a few 180B parts and asst Datsun parts and some Nissan parts for sale.

Datsun Parts:
1 x 13'' Steelie tyre is stuffed $5


2 x 13" Steelies matching pair tyres are stuffed $10 SOLD


Throttle linkages from 180B may fit other L series models?? $5


Heater core and heater controls from 180B unsure if core is in good cond $20



180B manual pedal box may fit others $30


910 service manual free to a good home


180B choke cable and bracket may fit others $5


Chrome number plate surround $10


2x Internal regualtors from 180B both have different plugs $5 each


180B fuel flap no lock $5


Nissan Stuff:

Shortnose R200 LSD 5x1 axel stubs 4.11 ratio Local buyers only please!
Looks like it has been dropped at some point a few chips in the rear cover doesnt leak oil also missing one stud $100




CA18DET Turbo Manifold Heat Shield $10 SOLD


CA18DET Inlet Manifold Braces $10


Assorted RB and CA plugs and valves oil pressure sensors etc $10 for the lot unknown cond


S14 PFL Front Caliper(just 1) I'm pretty sure the other one is Barts somewhere if i can find it the pair will be $30 otherwise just $10 for the one


RB20DET Turbo oil drain $5 SOLD


T25/g/28 Turbo oil drain brand new never used $10 SOLD


Nissan bonnet struts x5 unsure of condition $20 for the lot


RB sandwich plates x3 the half one is a bit bent but should be easy to straighten $20 for lot


Nissan gearbox crossmember has an A stamped into it under the rubber mount unsure what its from $20 SOLD


CA brackets and under drive pully(I think?) $20 for the lot SOLD


Prices can be negotiated want all these gone asap so will biff out most of it it doesnt sell. Cheers

I'll take the RB oil drain greg.
I'm failry sure I gave back the caliper? I'll have a look for it this week.

Sweet man, it could be at your mums place??

Well take the t25 oil drain Greg

Sent from my GT-I9100 using Tapatalk

Sweet Dan I'll bring it over next time I'm round

could you please explain how that big ca18 inlet manifold brace works? one came sitting in my silvia and i didn't have a clue wat it was

Can I grab those two 13" rims off you? They are a off a Datsun aren't they? Saves me using the Z mags on the new trailer as they are probably better on a zed.

The big brace bolts to the underside of the manifold and to the block down behind the alternator.
The small ones go in around the fuel rail

Sent from my GT-I9100 using Tapatalk

Im keen on the manifold heat shield thanks.

240znz wrote:Can I grab those two 13" rims off you? They are a off a Datsun aren't they? Saves me using the Z mags on the new trailer as they are probably better on a zed.

There yours James, they came off my 180B so are the datsun stud pattern