New Zealand Datsun Club

Howdy all,

I have put this up on the Facebook page, but thought I ought to do so here too. I am looking at purchasing a sway bar, short shifter and strut bar/brace for my 1200 from Mad Dat in Adelaide, Australia (to be shipped to Christchurch, NZ). If anyone is keen on any of the above (possibly any other parts), message me as we may be able to spread the freight cost (part prices are available via http://www.maddat.com.au" onclick="window.open(this.href);return false;). Cheers!

- Braasy

SO FAR WE HAVE INTEREST FROM THE FOLLOWING, FOR THE FOLLOWING:

@ braasmonkey -- 1 x 1200 Conversion Sway Bar Kit [SWB1200] @ AUD $280
@ braasmonkey -- 1 x Short Throw Shifter (A-Series Gearbox) [SSRA-S] @ AUD $160
@ braasmonkey -- 1 x Strut Brace (1200) [SB1200] @ AUD $220
@ joelbrown -- 1 x Short Throw Shifter (A-Series Gearbox) [SSRA-S] @ AUD $160
@ Garth -- 1 x 1200 Conversion Sway Bar Kit [SWB1200] @ AUD $280
@ torqued -- 1 x 1600 Conversion Sway Bar Kit [SWB1600TRUST] @ AUD $280

I WILL UPDATE THIS POST WITH ANY CHANGES SO I HAVE A LIST TO GO OFF OF. WITH REGARDS TO TAX, WILL CROSS THIS BRIDGE WHEN WE COME TO IT (ADDITIONAL TAX THAT IS - ALL PRICES ARE INCLUSIVE OF GST). AM LOOKING TO FINALISE PURCHASE WEDNESDAY THIS WEEK TO GIVE OTHERS A CHANCE TO PLACE THEIR ORDERS. GET IN QUICK!!

Would be keen on a sway bar but would need measurements and $$$$

Sent from my GT-I9300 using Tapatalk 2

Yes could be keen,
Will just have to follow up on some measurements I have been supplied by Ging.
Will let you know over the next few days.

Just a little worried regarding Tax if we get stung

Jump on board folks, the more the better.
Im already in for an A-series short shift kit

torqued wrote:Yes could be keen,
Will just have to follow up on some measurements I have been supplied by Ging.
Will let you know over the next few days.

Just a little worried regarding Tax if we get stung

Care to share said measurements? No doubt 510/610 sway bars are similar and would be good to know for future reference.

Sent from my GT-I9300 using Tapatalk 2

Pm sent, needing one of them sway bars

I just had a look at the Maddat website, and my sway bar does not look like the one on their website. I purchased it from a member here as a "MadDat" sway bar, but can only assume they have changed their design or something.

EDIT:
So looking through their catalogue, my 510 MadDat sway bar is in fact the one they sell for a Stanza.. Feck! I need to go get another sway bar link and test out the fitting.

This is the measurements I got from Maddat themselves Ging and Greg.

The inside length across the front is 500mm, from the front to the D saddles is 200mm and the length of where the D saddles is 130mm. The D saddles mount into the standard position.

Have updated the first post with interested parties and stock (with prices). Get in quick, will update with any changes as they occur!

- Braasy

I think you will the A series short shifters are AU$160.... AU$120 is for the R30 stumpys...