New Zealand Datsun Club

Having a bit of a tidy up of the garage so here's a list of things that need to go:

Chrome Air Filter for standard A12-A15 Carb, : Clamps onto top of carb, will need a new filter element: $25



Sway Bar,Powder coated Yellow, 20mm diameter. Not sure if its of a B210 or B310 - Can measure if needed $40



Dellorto DHLA 40 Parts - Enough to build one complete carb and have some spare parts. $150





Inlet Manifold for A12 - Suits 40mm Side Draughts $100




Datsun 1200 Castor Rods - Extra thread machined for more castor adjustment ( Suits standard struts and control arms) $35


White Gauge Cluster for Datsun 1200 -Includes Tacho $80



A series Heavy Duty Valve Springs - Suit a mild cam $50



Roadstar Ute Dash Cluster No speedo - Has damaged PCB tracks $20


Open to offers as well if nothing sells.
Cheers
Cam

Dibs on sway bar if b210!!
Can you measure please??

I'm keen on those dellorto parts, can you give some details about what's there, jet sizes choke sizes etc, and is there are fourth auxiliary Venturi? Could only see three in the pic
Cheers

Tony_Whenua wrote:Dibs on sway bar if b210!!
Can you measure please??

Measured:

could be keen on the valve springs.
will have a think about it, and if it will suit my application

detdat wrote:

Tony_Whenua wrote:Dibs on sway bar if b210!!
Can you measure please??

Measured:

B310 is 955mm right so this one should be sweet ... Any one able to confirm this??
I couldn't find any info on b210 measurements

I tried to fit a 310 sway bar to my coupe a while back - no good, as was too long by about 30mm (?).
needs to be 210 to fit easily

I can measure mine (120y) tonight if that helps? they are the same size (but thicker) than the 1200 ones yeh?

beaver wrote:I can measure mine (120y) tonight if that helps? they are the same size (but thicker) than the 1200 ones yeh?

Thanks man that'd be great. I'll try measure my 1200 tonight too and see what that comes up as

Any news on the dellorto parts?