Page 1 of 1
R180 Diff help needed
Posted: Sat Oct 03, 2009 6:17 pm
by Jabo
So im currently in the process of making my LSD from a Subaru diff and my diff. I need to get the LSD Centre out of the subaru diff so I can change the crown wheel but I Cant figure out how to get the outer bearings off so the centre will slide out.
please some one help
Chur
Re: R180 Diff help needed
Posted: Sun Oct 04, 2009 1:42 pm
by Bartman
I think that you have to undo the side plates. The bearing cups are pressed into them. With both of them removed, you should be able to wiggle and jiggle the center out.
Unless you are replacing the bearing on the lsd bit, make sure you keep the bearing cups matched up to their respective bearing.
Re: R180 Diff help needed
Posted: Sun Oct 04, 2009 1:45 pm
by kartboy
I heard a rumour that you were beyond help..lol
Re: R180 Diff help needed
Posted: Sun Oct 04, 2009 2:28 pm
by Jabo
Thats true I am beyond help but my diff isnt. thats what I thought Bart but I dont see any way the centre will come out with the bearings attached to the sides theres not enough room... Ill have another go later
Re: R180 Diff help needed
Posted: Sun Oct 04, 2009 2:37 pm
by Godzilladat
As bart said, just use a pry bar to lever the centre out once you have removed the 2 bearing holders (4 bolts).