New Zealand Datsun Club

hi ya,

I have a A15 I'm working on as I'm almost ready to install with the 5 speed I had a couple of questions..

1. I understand there are different brass bushings of some sort that go on the gearbox shaft and these have slight size differences depending on a 'factor'. What size bush do I need to fit the A15 to the 60A gearbox? does it change size depending on whether I have the additional spacer plate between the two?

2. Does anyone have a clutch fork for the 5 speed and spring they would part with?

3. Still looking for a manifold from A15 head to twin dellortos-cant find the guy who used to sell on TM?

thanks in advance

All A series spigot bushings are the same. AFAIK.

I have new brass bushes at home, only 1 size for a series

yes I will also have fork and spring too

the guy selling them new off trademe was philspeed in chch for about 340ish that's the only new ones on there I think

Palm side have manifolds listed on their website

yeah ive seen palmside although I can get them cheaper through oz direct. Had hoped to track down philspeed for the cheaper option. will try and Pm him.

Thanks tls sunny il PM you now.