New Zealand Datsun Club

Ok so I've got to put my normal full beams back in instead of my aircraft landing lights for cert but I think I'm missing some clips or something
They just don't quite fit. Any one got any ideas or could check theirs for me please?

I've checked my Haynes manual and it shows nothing but my driving lamps have www clips

Lamps with clips (although they are spot welded to the lamp)


Housing:


Full beam lamp



Sent from my iPhone using Tapatalk

I had this issue with mine, ( now this was a few years ago )
I think the issue was difference between inner and outer bulbs.

Hmmm cheers man I shall have a look at that don't remember taking the others out but def could be s possibility


Sent from my iPhone using Tapatalk

outer lights should have 3 prongs
and inner lights should only have 2

from my memory there is slight different mounting/alignment between the 2

Oh god I bet I've thrown the wrong one out hHaha


Sent from my iPhone using Tapatalk

Forums for the win, thanks all was trying to put the non full beams in Ahahaha


Sent from my iPhone using Tapatalk

Right just to finish this post of so it might be useful to someone one day..

810 180b headlight assesmbly

Normal lights on the outer with three prongs.

Full beam on the inner ( 2 prongs)

The cups that holds the lamps are can be used on either side (but mount differently depending on the side)

Normal lamps have a different mounting pattern so you can't swap either cups or lamps from inner to outer

That should do it.




Sent from my iPhone using Tapatalk