New Zealand Datsun Club

Hi guys just thought I would share my project with you.
Its a 75 gn620 which I am in the middle of upgrading to an sr20, so far I have the engine mounted and have got it running . The next stage is to get a radiator, a short shifter and get a drive shaft made up which will be happening as soon as I have saved up some money saved up.




Sent from my GT-P5110 using Tapatalk

New mounting points and old engine Sent from my GT-P5110 using Tapatalk

nice one!
do you have a picture of the clearance of the drag link on the sump?

I'll take one when I have made up the rear mount. But she's pretty close

Sent from my Nexus 5 using Tapatalk

Brought a radiator this morning. It's a 52mm thick half size Honda radiator Sent from my Nexus 5 using Tapatalk

I think I might have some clearance issues



Has anyone used these products before?
http://www.trademe.co.nz/motors/car-par ... 963810.htm" onclick="window.open(this.href);return false;
http://www.trademe.co.nz/motors/car-par ... 029667.htm" onclick="window.open(this.href);return false;

They look pretty ugly but they will do the trick as the radiator outlets are a different size to the engine

Tidied up the wiring in the engine bay a little bit and made a loom for the fuel pump and fuel sender unit. Also wired up the rev light's.
Sent from my Nexus 5 using Tapatalk

I'm actually planning the exact same swap for my 620.
I have a motor from an s14.
Keep your updates coming.

Sweet will do are you going to go turbo or na

Sent from my Nexus 5 using Tapatalk

NA to begin with.
Then I'll likely fit an Eaton M62 supercharger. It looks like it should be pretty easy.

What are those superchargers worth? I'd be interested to see how that goes.

Sent from my GT-P5110 using Tapatalk