I have spent a few hours today doing wiring, I quite enjoy this work,
but it is very time consuming, took me about 3 hours to do one run,
which had the injectors, TPS, temp sensor, VR signal. but I have
done a reasonable job, all joints are soldered properly, heat shrunk,
insulation taped, and cable eater fitted round the outside.
My next load of acoustic dampening materials arrived, man it is
heavy!!! each sheet 1.35m x 1.6m weighs around 10kg! I have
2x sheets to fit, it is quite difficult to work with, but it is great
stuff, I think it will make it a huge difference to the quietness
when I eventually get this up and running. basically a half sheet
fitted to do rear passenger floor area, will do front floor and
firewall, and probably boot space as well. This product is
Pyrotek brand, and is a composite system, and it is a layer of
4kg/m2 mass loaded vinyl, over a 6mm foam decoupler layer.
it also has a thin fireproof/insulating foil backing.
