I have spent a few hours today doing wiring, I quite enjoy this work,
but it is very time consuming, took me about 3 hours to do one run,
which had the injectors, TPS, temp sensor, VR signal. but I have
done a reasonable job, all joints are soldered properly, heat shrunk,
insulation taped, and cable eater fitted round the outside.
![Image](http://imageshack.us/a/img707/1776/p3040440.jpg)
![Image](http://imageshack.us/a/img542/4922/p3040439.jpg)
![Image](http://imageshack.us/a/img24/4706/p3040438s.jpg)
My next load of acoustic dampening materials arrived, man it is
heavy!!! each sheet 1.35m x 1.6m weighs around 10kg! I have
2x sheets to fit, it is quite difficult to work with, but it is great
stuff, I think it will make it a huge difference to the quietness
when I eventually get this up and running. basically a half sheet
fitted to do rear passenger floor area, will do front floor and
firewall, and probably boot space as well. This product is
Pyrotek brand, and is a composite system, and it is a layer of
4kg/m2 mass loaded vinyl, over a 6mm foam decoupler layer.
it also has a thin fireproof/insulating foil backing.
![Image](http://imageshack.us/a/img526/6100/p3040437.jpg)
![Image](http://imageshack.us/a/img208/4180/p3040436.jpg)